First post, by Mallabar
Hello,
I have a problem concerning the serial Interface.
An Old Software get some Data via COM2, unfortunatly when I start the Software I get the following Message in the Status Window:
Serial1: Errors: Framing 0, Parity 0, Overrun RX:0 (IF0:0), TX:1, Break 0
In the DOSBox Conf I added the following line:
serial1=directseriel realport:COM2
The other serials are all disabled.
The same Message occur, if I use dumme instead of the settings above.
Is there anything I have to do in addition ta make this work?
I get the Same Message when I use COM1.
with kind regards